Machine-Type: M0653
Ultrasonic cutting
Working width:
Type 1:
40cm - 140cm
Type of material to cut:
flat
Consisting of the following modules:
- Base frame
- Extractor with dancer system
- Circle- and x-cutter with ultrasonic cutting head (thermal cutting)
- Transport roller system with length measuring device
- Cross cutter with ultrasonic cutting head. (thermal cutting)
Cutting shapes:
Options:
Description:
Ultrasonic cross, circle and x- cutting machine for the production of high-quality BIG-BAGs. With the ultrasonic cutting system, coated and uncoated material can be cut. The cutting edges are thermally sealed, a beading at the cutting edges is excluded during ultrasonic cutting. In conventional hot cutting systems, suction devices are required for the resulting cutting vapors; these are not necessary during ultrasonic cutting. Either the cross cutter or the circle cutter can be used. The programmable work data, which refer to the respective material, can be stored in an optional recipe program and reactivated by simply pressing a key combination. All electronic machine parameters can also be saved via the control panel.
Detailed Options:
Lifting devices with edge control
This lifting device with edge control, model V3130, can handle material rolls up to max. Lift 1000 kg. Next, the station with a receiving rod and two rings, which serve for lateral fixation of the rollers, stocked. A product edge is constantly scanned during the run over 2 photocells and automatically corrected by the integrated actuator when the goods are running. The material web therefore always enters a defined position in the subsequent machine. The applied brake band reduces the running of the roller during a stop.
Line and dot marking system with pen
V2001-02 Inexpensive marking device with pen holders and rail system for applying lines and / or dots. When marking points, the material flow stops for a short time and the pen is lowered onto the material.
Fast marking system with spray head
This marking system applies dots and lines without stopping the material. This system can be integrated into almost all types of machines as it uses its own control electronics. The system is integrated in a compact frame which also allows installation in third-party systems.
Slitter with ultrasound (hot cutting)
For separating synthetic fabrics when a smaller width of material or center cut is needed. The cut edge is very clean and has no discoloration or beading of the material. In addition, the edge is sealed during the cut, which prevents tearing of the fabric edge.
Automatic depositing device with gripper u. Lift table
This depositing system is used when an automatic storage of the blanks is required. The material is taken over by the integrated gripper system behind the cross cutting system and extended to length. Once the length has been reached, the cross-section is made and the material is deposited on the lifting table. The lift table lowers automatically when the cut pile becomes larger.
Stacking table
The storage table consists of a tubular steel frame and table top. On request, this can be ordered with a false floor. The table depth is 100cm. The table width results from the working width of the machine.
Technical Data:
| Working width: | 140cm (special sizes on request) |
| Cuttting system: | Ultrasonic cutting |
| Circle cutter: | Ø 200mm – 590mm infinitely adjustable (special sizes on request) |
| X-Cutter: | 200mm – 590mm infinitely adjustable (special sizes on request) |
| Power connection: | 400V / 50Hz |
| Compressed air connection: | approx. 8bar |
| Operating air pressure: | approx. 6bar |